Heater Issues

As we mentioned in our previous post, evening temperatures in Mazama Campground were reaching the low 40s. Our Pleasureway Plateau XLTS is equipped with a Varioheat propane-fired heater manufactured by Truma. It was cold in the morning so we turned on the heater.

All RV heaters run checks before igniting the propane and the Truma Varioheat is no different. First the fan will turn on to ensure that air is able to circulate through the heater. Then the clicking of the igniter is audible followed by the woosh sound of the propane ignition. That all went well and soon warm air entered the coach. About five minutes later the heater fan speeds up to high and we can hear the propane valve close. The spider control panel shows “SEE TRUMA SCREEN” which indicates that there is an error with either the furnace or water heater.

This photo was taken the next day, hence the time of 6PM

The “Truma Screen” is the CP Plus controller, which is conveniently <sarcasm> located under the drivers side ottoman. While it is not difficult to reach the CP Plus, it does require removal of the ottoman pillow, opening the drawer, pulling out the bed support board and reaching in-between the slats to reach the CP Plus control. Here is a video showing the steps to reach the CP Plus control.

Truma error codes have have three components. The first letter is either an E (error) or W (warning). The second number is the actual error code. In our case it was 27. The final letter indicates which appliance has the the issue. W indicates the water heater and H indicates the furnace. Below is the explanation for a W 27 H error code means

W 27 H (warm air outlets blocked circulated air intake blocked EN end outlet closed)

  • What it means: This error occurs when the circulated air intake or the warm air outlet is blocked.
  • How to Troubleshoot: Check all outlet and intake openings and clear any blockages.

The heating systems in some RVs are ducted and the ducts can be opened or closed in order to direct air all the spaces in the RV. The design of our heating system is very simple. The hot air exits out of the vent on the right and the cool air returns to the heater through the vent on the left. It was clear that both vent ports were fully open. We could only postulate that the heat duct located in the cabinet may have dislodged and was causing the error.

Air return on left. Warm air supply on right.

Sadly, the heater and its associated ductwork are located under the refrigerator. Access to that area requires removal of the refrigerator and disassembly of the base of the refrigerator cabinet. That was not going to happen until we returned home! We were resigned to using our sleeping bags and a space heater (when we had electricity) to keep warm for the rest of our trip. We would soon be heading south to New Mexico and Texas, so we knew that we were not going to need the heat for the remainder of our trip.

We did an internet search and found a few posts suggesting that camping at high elevation can cause a W 27 H error. We reached out to Truma about this and received this explanation.

Mazama campground is at 4,000 feet elevation and according to Truma that elevation was enough to cause this problem. We were pleased with the prompt response from Truma but a bit perplexed by this explanation. We have camped in our current RV at Craters of Moon National Monument which is at 5,900 feet and at even higher elevations both in our current RV and our former Ontour 2.2 and never experienced this issue with the Varioheat.

Future Joe here. I’m writing this paragraph at the end of October where we are camping on the east coast and the Truma Varioheat is working well. So, no need to worry about us being cold. 🥶

Please leave a comment if you have experienced this error or know more about it.

Thanks for traveling along with us.


Discover more from On Tour Journal

Subscribe to get the latest posts sent to your email.

2 responses to “Heater Issues”

  1. Dave from Truma in Lakeland FL gave a talk and took questions at the Sarasota Rally. He mentioned that the appliances are sensitive to propane pressure. Do you know what the LP pressure is in your rig? Maybe the regulator is starting to fail.

    I asked if there is a sail switch in the varioheat. Was happy to hear that there is not. The varioheat monitors fan speed and resistance and the device can ramp up to burn off debris in the system.

  2. Mark

    Thank you for the information. I will rig up a pressure gauge with a quick connect and check pressure at the BBQ port. A Truma rep at the Hershey RV show confirmed that high altitude can cause this error because at elevation air is less dense and cannot carry off the heat from the heat exchanger. Other Pleasure-way owners have experienced this problem with their heater.

    I have read that the Truma cCombi can be configured with a different propane orifice to prevent this error. Not so with the Varioheat.

    We have camped at high elevation many times in our Ontour and never experienced this. Its something we will keep an eye on next travel season.

Leave a Reply